منزل المنتجاتمنتجات الكابلات هانيويل

51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester

شهادة
الصين IRONMAN TECHNOLOGY CO., LTD الشهادات
زبون مراجعة
"نقدر مساعدتكم الكريمة."

—— السيدة غلوريا

ابن دردش الآن

51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester

51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester
51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester 51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester

صورة كبيرة :  51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester

تفاصيل المنتج:
مكان المنشأ: الولايات المتحدة الأمريكية
اسم العلامة التجارية: Honeywell
رقم الموديل: 51303793-050
شروط الدفع والشحن:
الحد الأدنى لكمية: 1 قطعة
الأسعار: USD
وقت التسليم: 3-5 أيام
شروط الدفع: T / T.

51303793-050 Cable New Condition Honeywell Products Products Set Rev G 3906 Tester

وصف
شرط: الأصل جديد ضمان: 12 شهر
شرط الشحن: DHL / TNT / UPS / FEDEX إلخ.
تسليط الضوء:

كابل الألياف الضوئية

,

mc pdoy22

كابلات الألياف البصرية

Fiber Optic Cable Types and Modes Introduction This section describes the sizes of approved fiber optic cables and their modal qualities. أنواع وأنماط كبلات الألياف الضوئية مقدمة يصف هذا القسم أحجام كبلات الألياف الضوئية المعتمدة وصفاتها الشكلية. Optical Fiber Types There are two types of fiber optic (FO) cable used in data communications. أنواع الألياف الضوئية هناك نوعان من كبلات الألياف الضوئية (FO) المستخدمة في اتصالات البيانات. These are multi mode (MM) and single mode (SM). هذه هي وضع متعدد (MM) ووضع واحد (SM). These terms refer to how the light travels down the cable. تشير هذه المصطلحات إلى كيفية انتقال الضوء إلى أسفل الكابل. MM uses a multiple paths, or modes, while SM uses a single mode. يستخدم MM مسارات أو أوضاع متعددة ، بينما يستخدم SM وضع واحد. Due to the construction of the components, including the light sources themselves, SM has greater bandwidth and can be used for longer distances than MM FO. نظرًا لبناء المكونات ، بما في ذلك مصادر الضوء نفسها ، فإن SM لديها عرض نطاق ترددي أكبر ويمكن استخدامها لمسافات أطول من MM FO. As the cost of the associated electronics drops, SM is becoming more the FO cable of choice for high performance networks. مع انخفاض تكلفة الإلكترونيات المرتبطة ، أصبحت SM أكثر كبل FO المفضل للشبكات عالية الأداء. MM comes in 2 diameters which are 62.5 and 50 µm. MM يأتي بأقطار 2 62.5 و 50 ميكرومتر. This refers to the “core” diameter, or the center of the optical strand. يشير هذا إلى قطر "القلب" ، أو مركز الشريط البصري. This number is followed by a / and another number, written as 62.5/125. ويتبع هذا الرقم ب / ورقم آخر مكتوب بالرقم 62.5 / 125. This indicates a fiber with a core diameter of 62.5 µm and a “cladding” or outer coating diameter of 125 µm. يشير هذا إلى ليف بقطر أساسي يبلغ 62.5 ميكرومتر وقطر "الكسوة" أو طلاء خارجي يبلغ 125 ميكرومتر. The cladding is what actually keeps the light in the core of the fiber. الكسوة هي ما يبقي الضوء في قلب الألياف. SM fiber is typically 8.3/125 µm. الألياف SM عادة ما تكون 8.3 / 125 ميكرومتر. The 50 µm MM was intended to increase the bandwidth of MM while still allowing the use of MM electronics. كان الغرض من الـ 50 ميكرومتر هو زيادة عرض النطاق الترددي لـ MM مع السماح باستخدام الإلكترونيات MM. As the cost of all facets of SM installation has fallen, SM fiber should be the fiber of choice for new installations. نظرًا لانخفاض تكلفة جميع جوانب تثبيت SM ، فيجب أن تكون ألياف SM هي الألياف المفضلة للتركيبات الجديدة. If there is legacy equipment that requires MM FO, a hybrid cable that contains both SM and MM FO should be considered. إذا كانت هناك معدات قديمة تتطلب MM FO ، فيجب مراعاة كبل هجين يحتوي على كل من SM و MM FO. FO Cable Jacketing Just as there are different types of ScTP copper cable, there are different types of FO cable construction and jacketing materials. غلاف الكابل FO كما أن هناك أنواع مختلفة من الكابلات النحاسية ScTP ، هناك أنواع مختلفة من بناء الكابل FO ومواد الغلاف. In a broad sense, there are three categories of cable jacketing. بالمعنى الواسع ، هناك ثلاث فئات من غلاف الكابل. These are: • Outside plant cable • Indoor/outdoor cable • Inside plant cable, which include plenum and riser versions Outside plant cable is intended only for use outside buildings and is not a listed assembly by the NEC for use indoors. هذه هي: • كبل المصنع الخارجي • كبل داخلي / خارجي • كبل المصنع الداخلي ، الذي يتضمن إصدارات كاملة ومرتفعة ، كبل المصنع الخارجي مخصص فقط للاستخدام في المباني الخارجية وهو ليس تجميعًا مدرجًا بواسطة NEC للاستخدام في الداخل. Its jacket is usually made of polyethylene (PE) and may include metallic armoring. عادة ما تكون السترة مصنوعة من البولي إيثيلين (PE) وقد تشمل الدروع المعدنية. Per Article 770.113 an unlisted cable may penetrate a building a maximum of 50' (15 m) before it is required to be terminated, spliced to a listed cable, or enclosed in conduit. وفقًا للمادة 770.113 ، قد يخترق الكبل غير المدرج مبنى بحد أقصى 50 بوصة (15 م) قبل أن يُطلب إنهائه أو توصيله بكابل مدرج أو وضعه في قناة. This is the most durable of the three jacket types. هذا هو أكثر أنواع السترات عمرًا.

 

 

Indoor/Outdoor cabling has a type of jacket that is UL listed for indoor riser and outdoor use, but cannot be used in a plenum airspace. تحتوي الكابلات الداخلية / الخارجية على نوع من السترة مدرج على قوائم UL للناقل الداخلي والاستخدام الخارجي ، ولكن لا يمكن استخدامه في المجال الجوي بكامله. This type of cabling typically has a polyvinyl chloride (PVC) jacket with ultra-violet (UV) stabilizers, and will also include some type of water blocking compound to enable it to be used outside. عادة ما يحتوي هذا النوع من الكابلات على سترة من البولي فينيل كلوريد (PVC) مزودة بمثبتات فوق بنفسجية (UV) ، وسيتضمن أيضًا نوعًا من مركب منع الماء لتمكين استخدامه في الخارج. This is considered to be a medium duty cable and meets the requirements of NEC Article 770 as long as the building environment is classified as a riser as opposed to a plenum. يعتبر هذا كبلًا متوسط ​​الخدمة ويلبي متطلبات المادة 770 من NEC طالما أن بيئة البناء مصنفة على أنها صاعدة بدلاً من الجلسة الكاملة. Inside plant cable can be a substantial assembly, but is not considered to be as rugged as a true outside plant or indoor/outdoor cable. يمكن أن يكون الكبل الداخلي داخل مجموعة كبيرة ، ولكن لا يعتبر متينًا مثل المصنع الخارجي الحقيقي أو الكبل الداخلي / الخارجي. An inside plant cable jacket is typically either PVC or Teflon, for plenum rated applications, and usually does not contain any water blocking mechanisms. عادة ما يكون غلاف كابل المصنع الداخلي إما PVC أو Teflon ، للتطبيقات المصنفة بكميات كبيرة ، وعادة لا يحتوي على أي آليات لحجب الماء. All types of jacketing are usually available in different armoring configurations, depending on site environmental requirements. عادة ما تكون جميع أنواع الطلاء متوفرة في تكوينات تدريع مختلفة ، اعتمادًا على المتطلبات البيئية للموقع. It is important to be mindful of grounding requirements when using armored cable. من المهم أن تضع في اعتبارك متطلبات التأريض عند استخدام الكبل المدرع.


 

Ironman Technology Co.، LTD

 

معلومات عنا:

نحن متخصصون في قطع الأتمتة والضوابط الصناعية ، PLCS ، DCS ، الوحدة / اللوح ، مزود الطاقة ، وحدة التحكم ، إلخ.

 


العلامة التجارية المميزة:
● HONEYWELL ● AB ● اومرون ● سيمنس ● شنايدر

● ROSEMOUNT ● ABB ● NOTIFIER ● MTL ● GE ● وغيرها الكثير!


 

NEW HONEYWELL 51303793-050 مجموعة كابل REV G 3906 TESTER

مهلة: 3-5 أيام

جديد مع ضمان سنة واحدة

 

 

 

 

 

نحن حسعر جيد على AB PLC و Omron PLC و Honeywell C200 و C300 ورقم الطراز مثل TC / TK / MC / CC / 511/512/513/514 وبعض سلع سلسلة FC ،
إذا كان لديك استفسار آخر ، الثابتة والمتنقلة لا تتردد في إبلاغي.
 
 

تفاصيل الاتصال
IRONMAN TECHNOLOGY CO., LTD

اتصل شخص: Sales Manager

الهاتف :: +8613510133539

إرسال استفسارك مباشرة لنا (0 / 3000)